CAL PUMP Torpedo T1500

[view large image]

CAL PUMP Torpedo T4000

[view large image]

CAL PUMP Torpedo T7500/T10000

[view large image]

IMPORTANT

	MUST be plugged in to properly grounded and GFCI (Ground Fault Circuit Interrupter) protected 120 Volt outlet !
	To ensure optimal performance and maximum pump life, pump must be sized according to the charts on the right
	For out of pond installation, please note that the Torpedo pumps are NOT suction pumps - they have to be installed below the waterline with gravity feed or used with a priming pot
	Not approved for use in swimming pools or salt water
	Ships from Oklahoma

Torpedo T10000 shown with priming pot
(for out-of-pond installation)

Torpedo Pumps are the first pumps of their kind engineered to be powerful, high-flow/low profile pumps that are lightweight and water-cooled. Their unique flow-through water jacketing uses no oil and allows these pumps to be used in or out of water. Their durable, non-corrosive construction, their ease of installation and use, and their versatility make them the pump of choice for many high-flow applications. These pumps operate in fresh or salt water environments. Perfect for ponds and water gardens, waterfalls and water displays, large irrigation systems, cooling and air conditioning systems, and high-volume re-circulation systems.

Key Features

	Unique flow-through water cooling - uses no oil for environmental safety
	20' power cord for convenience (Torpedo T1500 and T4000)
	40' power cord for convenience (Torpedo T7500 and T10000)
	Non-corrosive construction for longevity
	High-flow output powers large biofilters, waterfalls and water displays
	Large intake and discharge for better flow
	Use in or out of water
	Suitable for salt water applications
	Convenient stainless steel handle for easy installation and service
	Sits upright in large skimmers using an optional filter basket
	Priming pot is available for above water level installation

Warranty

1-year manufacturer's limited warranty

Pump Sizing

Continuous operation of these pumps in a pond or waterfall requires that the pump be sized for each specific installation. Pumps last longer and use less electricity when operated in the mid-range of their performance curve (see charts below). To calculate this, measure the height in feet from the surface of the pond water to the point where the water returns to the pond (perhaps a waterfall spillway). Add one (1) foot for every 90 degree elbow through which the water passes from the pump to the point of return. Add one (1) foot for every ten (10) foot length of tubing. This will provide the total height that the pump must move the water. Locate that height in feet on the vertical axis of the charts below and read to he right until you intersect the dotted red line. It is best to operate the pump in the head height shown by the green area. If the lines intersect too far to the left of the graph you must choose a larger pump. If they intersect too far to he right you may either choose a smaller pump or install a ball valve at the discharge of the pump. By slightly closing the ball valve, never more than one third, you will create additional back-pressure on the pump that will allow it to operate correctly in the mid-range of its performance curve. Proper sizing of the pump to your specific installation will ensure optimal performance and maximum pump life.

T1500 Pump Curve [view large image]	T4000 Pump Curve [view large image]
T7500 Pump Curve [view large image]	T10000 Pump Curve [view large image]